Xerox 4850 HighLight Color Message Manual page 96

OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-38
OS1961 Simplex feeding from tray 2 may cause incomplete print
quality adjustment
Tray 2 does not have adequate capacity to perform a simplex
mode print quality adjustment (PQA) under certain conditions.
Action Select a paper tray different from the one you are currently using
to feed your simplex print job.
OS1962 The 'PQA CONTINUE' parameter is not allowed with the
current selections
You entered the PQA command with the CONTINUE option, but
your configuration does not meet the requirements that allow
the CONTINUE keyword with PQA.
Action 1. Make sure you define the feeder trays containing the
required stock for the PQA as current trays in a valid cluster.
2. With the dual stacker, specify different output trays for PQA
and the print job. Refer to the Xerox 4850 HighLight Color
LPS Operator Guide or to the Xerox 4890 HighLight Color
LPS Operator Guide for more information.
OS1963 Print quality adjustment is already pending
You entered a PQA command while another one was pending.
The system ignores the second PQA command.
Action Use PQA CANCEL to cancel the pending PQA.
OS1964 No print quality adjustment is pending
You entered a PQA CANCEL command when no print quality
adjustment was pending.
Action None.
OS1965 Print quality adjustment was unsuccessful
The system failed to complete print quality adjustment.
Action 1. Retry running PQA.
2. If the message reappears, contact your service representative.
OS1967 Caution: PQA 'CONTINUE' parameter may cause job sheets
to be stacked on top of adjustment sheets
You entered the CONTINUE option with the PQA command, but
the system has only one output tray. The sheets of paper for
your job may be stacked on top of the sheets used for the print
quality adjustment.
Action None.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE