Table of Contents
Advertisement
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-70
OS3050
Stitcher out of wire
The stitcher ran out of wire.
Action
Perform one of the following actions:
•
Replace the stitcher wire if you are ACT-trained.
•
Contact your service representative.
OS3190
Close rear door
The rear door is not securely closed.
Action
Close the rear door of the printer before starting or resuming
your job.
OS3400
Printer jammed . . . clear paper path
Change, then push 'BOTTLE/FILTER RESET' button
Printer jam . . . See printer message
A paper jam occurred at the area indicated on the printer control
console display.
Action
Refer to the printer control console display for instructional
messages.
OS3700
Suspected page-delivery error. Check output.
The last printed sheet may not have reached the stacker tray.
Action
Check the stacker trays. Remove any sheet that was jammed
while it was entering the tray.
OS3705
Suspect set delivery error.
There is an apparent set delivery problem.
Action
Visually inspect the sets.
OS3710
Set integrity problem. Partial set ejected.
The integrity of the current set in the collection area of the
stitcher/stacker is questionable. It is likely that a page was
skipped.
Action
1. Check the output.
2. Press <CON> to resume printing.
OS3711
Report integrity problem. Check output
The integrity of the current report in the output stacker
collection area is questionable.
Action
Visually inspect the report.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
Advertisement
Table of Contents
