Xerox 4850 HighLight Color Message Manual page 54

HOST INTERFACE PROCESSOR (HIP) MESSAGES
7-12
HP2320 Invalid command with current HOST type.
You entered a HIP command that is not allowed with this host.
Action None.
HP2330 Invalid command with no HOST specified.
You must select a host before the system can carry out the
command.
Action 1. Select a host.
2. Reenter the command.
HP2340 Can not CHANGE: HIP must be in 'STOP' state.
To use the HIP CHANGE command, HIP must be in the stop
state, and the file must be completely received and in the
pending state.
Action Enter the HIP STOP command and reenter the HIP CHANGE
command when the job is in the pending state.
HP2341 Can not CHANGE: Job must be in 'PENDING' state.
To use the HIP CHANGE command, HIP must be in the stop
state, and the file must be completely received and in the
pending state.
Action Reenter the command when the job is in the pending state.
HP2342 Can not CHANGE: CHANGE process already active.
Only one HIP CHANGE command can be executed at one time.
Action Allow the current change process to complete and reenter the
HIP CHANGE command.
HP2343 Can not CHANGE: invalid file specification.
You specified an output file type that is invalid or not a type
identified in the ACCEPT list.
Action Reenter the command specifying the correct file type.
HP2344 Can not CHANGE: Job does not exist.
You specified a job (jid) that does not exist.
Action Reenter the command specifying the correct job.
HP2345 Can not CHANGE: Output file already exists.
You specified a file that is already resident on the disk.
Action Reenter the HIP CHANGE command specifying a different
filename.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE