Rigol MSO4000 User Manual page 106

RIGOL
B
Slope time
When the Slope Condition is set to

press Time and use
10 ns to 1 s.
When the Slope Condition is set to

and Lower Limit and use
range of time upper limit is from 20 ns to 1 s. The range of the time lower limit is
from 10 ns to 999 ms. Note that the time lower limit must be lower than the
upper limit.
Vertical Window:
Press Vertical to select the desired vertical window. Note that under the "Slope"
trigger menu, you can also press down the trigger level knob continuously to switch
the vertical window.
You can select the boundaries of the trigger level and then use TRIGGER
to adjust the trigger level. During the adjustment, two orange trigger level lines and
two trigger marks (
the rotation of the knob. The trigger level value and the slope value are displayed at
the lower left corner of the screen. The trigger level lines and trigger marks
disappear in about 2 seconds after the knob has stopped rotating. When the Slope
Condition is set to
slope range will be displayed at the lower left corner of the screen.
UpLevel
=
SlewRate
TimeSettin
The adjustment mode of the trigger level is different when different vertical window
5-18
A
Positive
to input the desired value. The range available is from
to input the desired values respectively. The
and ) appear on the screen and move up and down with
or
−
LowLevel
SlewRate
gValue
The upper limit of trigger level (Up Level)
The lower limit of trigger level (Low Level)
,
or
, the current trigger level value and the
−
UpLevel LowLevel
=
TimeUpperL imit
MSO4000/DS4000 User's Guide
5 To Trigger the Oscilloscope
, or
, press Upper Limit
LEVEL
−
UpLevel LowLevel
~
TimeLowerL
,
imit