Auto Measurement; Quick Measurement After Auto - Rigol MSO4000 User Manual

6 To Make Measurements

Auto Measurement

MSO4000/DS4000 provides auto measurements of 24 waveform parameters and the
statistics and analysis of the measurement results. What's more, you can also use
the frequency counter to realize more precise frequency measurement.

Quick Measurement after AUTO

When the oscilloscope is correctly connected and has detected input signal, press
AUTO to enable the waveform auto setting function and open the following function
menu:
Note: The auto setting function requires that the frequency of the signal under test
should be no lower than 50 Hz, the duty cycle be greater than 1% and the amplitude
be at least 20 mVpp. If the parameters of the signal under test exceed these limits,
the quick parameter measurement items might not be displayed in the pop-up menu.
MSO4000D/S4000 User's Guide
Single-period: measure the "Period" and "Frequency "of the
current signal within a single period and display the measurement
results at the bottom of the screen.
Multi-period: measure the "Period" and "Frequency "of the
current signal within multiple periods and display the
measurement results at the bottom of the screen.
Rise Time: measure the "Rise Time" of the current signal and
display the measurement result at the bottom of the screen.
Fall Time: measure the "Fall Time" of the current signal and
display the measurement result at the bottom of the screen.
RIGOL
6-13