Remote Control Via Lan - Rigol MSO4000 User Manual

RIGOL

Remote Control via LAN

1. Connect the device
Connect the oscilloscope to your LAN using a network cable.
2. Configure network parameters
Configure the network parameters of the oscilloscope according to the
description in
3. Search device resource
Start up the Ultra Sigma and click
figure below is displayed. Click
software searches for the oscilloscope resources currently connected to the LAN
and the resources found are displayed at the right of the window. As shown in
Figure (b), select the desired resource name and click
Note that if you want to remove the unwanted resource, select the resource
name and click
15-6
Setting".
"LAN
(as shown in Figure (c)).
. The window as shown in the
(as shown in Figure (a)) and the
MSO4000/DS4000 User's Guide
15 Remote Control
to add it.
Figure (a)