Rigol MSO4000 User Manual page 188

RIGOL
6. Threshold
Refer to the introduction in
7. Display-related Setting
Press Format to set the display format of the bus to Hex, Decimal, Binary or
ASCII.
Press Offset and use
Press BusStatus to enable or disable bus display.
8. Decoding Table
The decoding table lists the decoded data, the corresponding line number, time
and error information in table format. This can be useful when observing longer
data transimissions by presenting the data in a tabular format.
Press Event Table  Event Table to select "ON" (note that this operation is
only available when BusStatus is set to "ON") to enter the decoding table
interface as shown in the figure below. If a USB storage device is currently
connected to the instrument, press Export to export the data table to the
external USB storage device in CSV format.
8-20
Decoding".
"Parallel
to adjust the vertical display position of the bus.
8 Protocol Decoding
MSO4000/DS4000 User's Guide