RIGOL
Cursor Measurement
Cursors are the horizontal and vertical marks that can be used to measure the X axis
values (usually Time) and Y axis values (usually Voltage) on a selected waveform.
Please connect the signal to the oscilloscope and obtain stable display before using
cursor measurement. All the
through cursor measurement.
Press Cursor Mode at the front panel and use
mode (the default is "OFF") and then press down the knob. The modes available are
"Manual", "Track", "Auto" and "X-Y".
6-26
"Auto
Measurement" parameters can be measured
6 To Make Measurements
to select the desired cursor
MSO4000/DS4000 User's Guide