Rigol MSO4000 User Manual page 121

5 To Trigger the Oscilloscope RIGOL
kb/s, 125 kb/s, 250 kb/s, 500 kb/s, 800 kb/s, 1 Mb/s or user. After "User" is selected,
press User and use
to input the desired rate within 1 kb/s and 10.0 Mb/s.
Sample Point:
Sample point is a point within a bit's time. The oscilloscope samples the bit level at
this point. "Sample point" is represented by the percentage of "the time from the
start of the bit's time to the sample point time" in the "bit's time".
Press SamplePoint and use
to modify the parameter with a step of 1% and the
range is from 5% to 95%.
1Bit
60%
70%
80%
Trigger Mode:
Press Sweep to select the Trigger Mode (page 5-3) under this trigger type as auto,
normal or single. The corresponding status light of the current trigger mode turns on.
Trigger Setting:
Press Setting to set the trigger parameters (trigger coupling, trigger holdoff and
noise rejection) under this trigger type.
Trigger Level:
Use TRIGGER LEVEL to modify the level. For details, please refer to the
Level" on page 5-9.
description of "Trigger
MSO4000D/S4000 User's Guide
5-33