10 Pass/Fail Test - Rigol MSO4000 User Manual

10 Pass/Fail Test

10 Pass/Fail Test
The MSO4000/DSO4000 features a Pass/Fail test that enables the ability to monitor
the change of an input signal and analyze whether the input signal is within a
user-defined limit mask. The test results can be displayed on the screen as well as be
declared by an audible beep or a pulse signal output from the [Trig
Out/Calibration] connector at the rear panel.
The contents of this chapter:
To Enable Pass/Fail Test

To Select Source

To Create Mask

Test and Ouput

To Save the Test Mask

To Load the Test Mask

MSO4000/DS4000 User's Guide
RIGOL
10-1