Time Base Mode; Y-T Mode - Rigol MSO4000 User Manual

RIGOL
3 To Set the Horizontal System

Time Base Mode

Press MENU in the horizontal control area (HORIZONTAL) at the front panel and
then press Time Base to select the time base mode of the oscilloscope and the
default is Y-T.

Y-T Mode

This mode is the main time base mode and is applicable to CH1 to CH4.
In this mode, the Y axis represents voltage and the X axis represents time. Note that
Delayed Sweep
only when this mode is enabled can be turned on.
MSO4000/DS4000 User's Guide
3-4