Channel Label - Rigol MSO4000 User Manual

RIGOL
2 To Set the Vertical System

Channel Label

You can modify the labels used to mark the analog channels (CH1 to CH4) at the left
side of the screen. The label is the number of the channel (such as ) by default
and the length of the label can not exceed 4 characters.
Press CH1 Label to enter the label modification interface as shown in the figure
below.
Name Input Area Keyboard Upper/Lower Case Switch
For example, change " " to " ".
Press Keyboard to select the "Keyboard" area. Select "Aa" using
and press
a
down to switch it to " A". Select "C" using and press down to input the
character. Use the same method to input "hn1".
To modify or delete the input character, press Name to select the "Name Input Area"
and use to select the character to be modified or deleted. Enter the desired
character or press Delete to delete the character selected.
After finishing the input, press OK to finish the modification and the channel label
will change to " ".
MSO4000/DS4000 User's Guide
2-10