Parallel Decoding - Rigol MSO4000 User Manual

RIGOL

Parallel Decoding

Parallel bus consists of a clock line and data lines. As shown in the figure below, CLK
is the clock line, while Bit0 and Bit1 are the 0 bit and 1st bit on the data line
respectively.
CLK
Bit0
Bit1
The oscilloscope will sample the channel data on the rising edge, falling edge or the
rising&falling edges of the clock and judge each data point (logic "1" or logic "0")
according to the preset threshold level.
Press Decode1  Decode to select "Parallel" and open the parallel decoding
function menu.
1. Clock Line Setting (CLK)
Press CLKChannel to select any channel (CH1 to CH4 or D0-D15) as the clock
channel. If "None" is selected, no clock channel is set.
Press Slope to set the oscilloscope to sample the channel data on the rising
edge ( ), falling edge (
channel is selected, the instrument will sample when the channel data jumps in
the decoding.
2. Data Line Setting
Set the bus bits

Press Bus Bits to set the data width of the parallel bus namely the number
of bits per frame. The default is 1 and the maximum is 20 bits (Bit0,
Bit...Bit19).
Specify data channel for each bit.

First, press CurrentBit to select the bit that needs to specify channel. The
default is 0 and the range available is always 1 smaller than the bus bits. For
8-2
) or rising&falling edges (
8 Protocol Decoding
). If no clock
MSO4000/DS4000 User's Guide