Remote Interface Configuration; Lan Setting - Rigol MSO4000 User Manual

RIGOL

Remote Interface Configuration

The MSO4000/DS4000 can communicate with PC via LAN, USB and GPIB (with the
USB-GPIB interface converter provided by RIGOL) buses. Please refer to the
introduction below to configure the corresponding interface before using the remote
interfaces.

LAN Setting

Press Utility  IO Setting  LAN Set to turn on the LAN setting interface. You
can view the network connection status and configure the network parameters.
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status
Network Status
Connect the oscilloscope to your local area network using the network cable. The
network hole of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
Net Config Success!

Acquire IP...

IP Conflict!

Unconnected!

DHCP Fail!

Read Status Fail!

14-2
14 System Function Setting
MSO4000/DS4000 User's Guide