Internal Options; Internal Options/General; Table 50: Internal Options/General - Grandstream Networks UCM6510 IP PBX User Manual

This section describes internal options that haven't been mentioned in previous sections yet. The settings
in this section can be applied globally to the UCM6510, including general configurations, jitter buffer, RTP
settings, hardware config and STUN monitor. The options can be accessed via web GUI->PBX->Internal
Options.

INTERNAL OPTIONS/GENERAL

General Preferences
Global OutBound CID
Global OutBound CID Name
Operator Extension
Ring Timeout
Record Prompt
Extension Preferences
Enforce Strong Passwords
Firmware Version 1.0.0.25
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299

INTERNAL OPTIONS

Table 50: Internal Options/General

Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Specify the operator extension, which will be dialed when users presses 0
to exit voicemail application. The operator extension can also be used in
IVR option.
Configure the number of seconds to ring an extension before the call
goes to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
If enabled, users will hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6510 will play voice
prompt "The call will be recorded". The default setting is "No".
If enabled, strong password will be enforced for the password created on
the UCM6510. The default setting is enabled.
Strong Password Rules:
 Password for voicemail, voicemail group, outbound route, DISA, call
queue and conference requires non-repetitive and non-sequential
digits, with a minimum length of 4 digits. Repetitive digits pattern
UCM6510 IP PBX User Manual Page 175 of 229