Internal Options; Internal Options/General; Table 40: Internal Options/General - Grandstream Networks UCM6108 User Manual

http://arttel.ru
This section describes internal options that haven't been mentioned in previous sections yet. The settings in
this section can be applied globally to the UCM6100, including general configurations, jitter buffer, RTP
settings, hardware config and STUN monitor. The options can be accessed via Web GUI->PBX->Internal
Options.

INTERNAL OPTIONS/GENERAL

General Preferences
Global OutBound CID
Global OutBound CID Name
Operator Extension
Ring Timeout
Record Prompt
Extension Preferences
Enable Random Password
Disable Extension Range
Firmware Version 1.0.2.21
http://arttel.ru/shop/ip-atc/ip-ats-grandstream-ucm6102

INTERNAL OPTIONS

Table 40: Internal Options/General

Configure the global CallerID used for all outbound calls when no other
CallerID is defined with higher priority. If no CallerID is defined for
extension or trunk, the global outbound CID will be used as CallerID.
Configure the global CallerID Name used for all outbound calls. If
configured, all outbound calls will have the CallerID Name set to this
name. If not, the extension's CallerID Name will be used.
Specify the operator extension, which will be dialed when users presses
0 to exit voicemail application. The operator extension can also be used
in IVR option.
Configure the number of seconds to ring an extension before the call
goes to the user's voicemail box. The default setting is 60.
Note:
This is the global value used for each extension if "Ring Timeout" field is
left empty on the extension configuration page.
If enabled, users will hear voice prompt before recording is started or
stopped. For example, before recording, the UCM6100 will play voice
prompt "The call will be recorded". The default setting is "No".
If enabled, random password will be generated when the extension is
created. The default setting is "Yes". It is recommended to enable it for
security purpose.
If set to "Yes", users
pre-configured/configured on the UCM6100. The default setting is "No".
UCM6100 Series IP PBX User Manual
could disable the extension
Page 122 of 159
range