Ring Group; Configure Ring Group; Table 37: Ring Group Parameters; Figure 45: Ring Group - Grandstream Networks UCM6510 User Manual

The UCM6510 supports ring group feature with different ring strategies applied to the ring group members.
This section describes the ring group configuration on the UCM6510.

CONFIGURE RING GROUP

Ring group settings can be accessed via web GUI->PBX->Call Features->Ring Group.

Click on "Create New Ring Group" to add ring group.

Click on to edit the ring group. The following table shows the ring group configuration parameters.

Click on to delete the ring group.
Ring Group Name
Extension
Ring Group Members
Ring Strategy
Ring Timeout on Each Member
Firmware Version 1.0.0.5

RING GROUP

Figure 45: Ring Group

Table 37: Ring Group Parameters

Configure ring group name to identify the ring group. Letters, digits, _
and - are allowed.
Configure the ring group extension.
Select available users from the left side to the ring group member list on
the right side. Click on
Select the ring strategy. The default setting is "Ring in order".

Ring simultaneously
Ring all the members at the same time when there is incoming call
to the ring group extension. If any of the member answers the call, it
will stop ringing.

Ring in order
Ring the members with the order configured in ring group list. If the
first member doesn't answer the call, it will stop ringing the first
member and start ringing the second member.
Configure the number of seconds to ring each member. If set to 0, it will
keep ringing. The default setting is 30 seconds.
UCM6510 IP PBX User Manual
to arrange the order.
Page 116 of 192