Uefi/Post Error Codes - Lenovo BladeCenter HS23E Problem Determination And Service Manual

UEFI/POST error codes

UEFI/POST diagnostic error codes can be generated when the server starts up or
while the server is running. UEFI/POST codes are logged in the IMM event log in
the server.
For each event code, the following fields are displayed:
Event identifier
Event description
Explanation
Severity
98
BladeCenter HS23E Type 8038 and 8039: Problem Determination and Service Guide
Table 8. Methods for viewing event logs
Condition
The blade server is not hung and is
connected to a network.
The blade server is not hung and is not
connected to a network.
The blade server is hung.
An identifier that uniquely identifies an event.
The logged message string that appears for an event.
Additional information to explain why the event occurred.
An indication of the level of concern for the condition. The following
severities can be displayed:
Table 9. Event severity levels
Severity
Informational
Action
Use any of the following methods:
v In a web browser, type the IP address of
the advanced management module and
go to the Event Log page.
v Run Portable or Installable DSA to view
the event logs or create an output file that
you can send to IBM service and support.
v Use IPMItool to view the system-event
log.
Use IPMItool locally to view the
system-event log.
v If DSA Preboot is installed, restart the
blade server and press F2 to start DSA
Preboot and view the event logs.
v If DSA Preboot is not installed, insert the
DSA Preboot CD and restart the blade
server to start DSA Preboot and view the
event logs.
v Alternatively, you can restart the blade
server and press F1 to start the Setup
utility and view the POST event log or
system-event log. For more information,
see "Viewing event logs through the
Setup utility" on page 97.
Description
An informational message is something that was recorded for
audit purposes, usually a user action or a change of states that is
normal behavior.