Example For Configuring Kompella Vpls; Figure 6-6 Networking Diagram For Configuring Kompella Vpls - Huawei Quidway S9300 Configuration Manual

6 VPLS Configuration

6.11.2 Example for Configuring Kompella VPLS

Networking Requirements
As shown in
connected to PE1 and CE2 is connected to PE2; CE1 and CE2 belong to the same VPLS network;
It is required to set up PWs by using BGP as the VPLS signaling, implement the automatic
discovery of VPLS PEs through VPN targets, and implement interworking between CE1 and
CE2.

Figure 6-6 Networking diagram for configuring Kompella VPLS

PE1
GE1/0/0
GE1/0/0
S9300
PE1
PE2
P
CE1
CE2
6-44
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 169.1.1.0 0.0.0.255
#
return
Figure 6-6, PE1 and PE2 are PEs to be enabled with the VPLS function; CE1 is
Loopback1
1.1.1.9/32
GE2/0/0
GE1/0/0
CE1
Interface
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 1/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1 Loopback1
2.2.2.9/32
GE2/0/0
GE1/0/0
P
VLANIF Interface
VLANIF 10
VLANIF 20
-
VLANIF 30
VLANIF 40
-
VLANIF 20
VLANIF 30
-
VLANIF 10
VLANIF 40
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3.3.3.9/32
PE2
GE2/0/0
GE1/0/0
CE2
IP Address
-
168.1.1.1/24
1.1.1.9/32
169.1.1.2/24
-
3.3.3.9/32
168.1.1.2/24
169.1.1.1/24
2.2.2.9/32
10.1.1.1/24
10.1.1.2/24
Issue 03 (2009-08-20)