Huawei Quidway S9300 Configuration Manual page 551

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the VLAN to which each interface belongs according to
The configuration details are not mentioned here.
Step 2 Configure an IGP on the MPLS backbone network.
PEs and ASBR-PEs on the backbone network can interwork by using an IGP.
In this example, IS-IS is used, and the configuration details are not mentioned here.
After the configuration, the IS-IS neighbor relationship is established between ASBR-PEs and
PEs in the same AS. Run the display isis peer command, and you can view that the status of
IS-IS neighbors is Up, and the PEs can learn loopback addresses from each other.
Take the display on PE1 as an example.
<PE1> display isis peer
System Id
0000.0000.0002
Total Peer(s): 1
ASBR-PEs and PEs in the same AS can ping each other successfully.
Take the display on PE1 as an example.
<PE1> ping 2.2.2.2
PING 2.2.2.2: 56
--- 2.2.2.2 ping statistics ---
Issue 03 (2009-08-20)
Configure basic MPLS functions on devices in the backbone network and establish dynamic
LSPs between PEs and ASBR-PEs in the same AS. Establish remote LDP sessions if PEs
and ASBR-PEs are indirectly connected.
Establish VPLS connections between PEs and ASBR-PEs in the same AS.
IS-IS data
IP addresses of remote peers
MPLS LSR IDs on PEs and ASBR-PEs
VSI IDs
NOTE
The S9300 only allows the CE to access the PE through a trunk.
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may occur.
Interface
Vlanif20
data bytes, press CTRL_C to break
Reply from 2.2.2.2: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 2.2.2.2: bytes=56 Sequence=2 ttl=255 time=90 ms
Reply from 2.2.2.2: bytes=56 Sequence=3 ttl=255 time=60 ms
Reply from 2.2.2.2: bytes=56 Sequence=4 ttl=255 time=60 ms
Reply from 2.2.2.2: bytes=56 Sequence=5 ttl=255 time=100 ms
5 packet(s) transmitted
5 packet(s) received
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Peer information for ISIS(1)
----------------------------
Circuit Id
0000000002
6 VPLS Configuration
Figure 6-9.
State HoldTime Type
Up 23s L1L2
PRI
--
6-69