Vll Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
About This Chapter
This chapter describes the principle, configuration procedure, and configuration examples of the
VLL.
4.1 Introduction to VLL
This section describes the principles of VLL.
4.2 VLL Features Supported by the S9300
This section describes the VLL features supported by the S9300.
4.3 Configuring a CCC VLL
This section describes how to configure the CCC VLL, that is how to transmit user data by using
a single label.
4.4 Configuring an SVC VLL
This section describes how to configure the SVC VLL, that is, how to transmit L2VPN
information without using signaling protocols.
4.5 Configuring a Martini VLL
This section describes how to configure the Martini VLL. The Martini VLL is easy to configure
and realizes L2VPN through the point-to-point link. LDP is used as the signaling protocol to
transmit Layer 2 information and the VC labels.
4.6 Configuring a Kompella VLL
This section describes how to configure the Kompella VLL, that is, how to implement VLL on
the MPLS network in end-to-end (CE-to-CE) mode. The Kompella VLL uses BGP to transmit
L2VPN information and VC labels.
4.7 Configuring Inter-AS Martini VLL
If the MPLS backbone network bearing the Martini VLL extends over multiple ASs, you can
adopt the multi-hop scheme.
4.8 Configuring the Inter-AS Kompella VLL
If the MPLS backbone network bearing the Kompella VLL extends over multiple ASs, you can
adopt the multi-hop scheme.
4.9 Configuring VLL FRR
Issue 03 (2009-08-20)
4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

VLL Configuration

4 VLL Configuration
4-1