Establishing The Configuration Task; Creating A Vsi And Configuring The Ldp Signaling - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN

6.4.1 Establishing the Configuration Task

Applicable Environment
If PE devices support the usage of LDP as the VPLS signaling, you can configure the Martini
VPLS service. To fully connect the PEs in a VPLS network through PWs, you need to set up
LDP sessions among all the PEs.
Pre-configuration Tasks
Before configuring Martini VPLS, complete the following tasks:
l
l
l
l
l
Data Preparation
To configure Martini VPLS, you need the following data.
No.
1
2
3
4

6.4.2 Creating a VSI and Configuring the LDP Signaling

Context
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
Issue 03 (2009-08-20)
Configuring the static routes or an IGP protocol on PE and P on the MPLS backbone
network to implement IP connectivity
Configuring LSR IDs and enabling MPLS and MPLS LDP on PEs and Ps
Enabling MPLS L2VPN on PEs
Establishing a tunnel between PEs to transmit user data
Setting up an LDP session if PEs are indirectly connected
Data
Name of a VSI
VSI ID
IP addresses of peers and the tunnel policy used for setting up the peer relationship
Type and number of an interface to which a VSI is bound
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 VPLS Configuration
6-15