Configuring The Tunnel Policy - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Pre-configuration Tasks
Before configuring a tunnel policy, complete the following tasks:
l
l
l
l
Data Preparation
To configure a tunnel policy for L3VPNs, you need the following data.
No.
1
2
3
4

1.4.2 Configuring the Tunnel Policy

Context
Do as follows on the PEs configured with the VPN instance.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
tunnel-policy policy-name
A tunnel policy is created and the tunnel policy view is displayed.
A tunnel policy corresponds to only one tunnel selection mode. If multiple tunnel selection
modes are required, you need to create multiple tunnel policies.
A tunnel policy can be applied to only one VPN instance. Multiple VPN instances, however,
can share one tunnel policy.
Step 3 Run:
tunnel select-seq { gre | lsp | cr-lsp }
The select-sequence mode and number of tunnels carrying out load balancing are set.
Issue 03 (2009-08-20)
Connecting interfaces and setting the physical parameters of each interface to make the
physical layer in Up state
Setting the parameters of the link layer protocol and the IP address of the interface to enable
the link layer protocol.
Creating the tunnel (LSP or MPLS TE tunnel) for the VPN instance
Configuring the VPN instance on the PE (refer to
this manual)
Data
Name of the tunnel policy
Priority sequence of tunnels
Number of tunnels carrying out load balancing
Name of the VPN instance where the tunnel policy is applied
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 VPN Tunnel Management
BGP/MPLS IP VPN Configuration
*
load-balance-number load-balance-number
in
1-9