Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed.
Step 4 Enable the route reflection for the routes of the BGP VPN instance on the RR.
l
l
Step 5 (Optional) Run:
rr-filter extended-list-number
The reflection policy is configured for the RR.
This command is required only on the RR.
Step 6 (Optional) Run:
reflect between-clients
Route reflection is enabled between clients.
By default, the route reflection between the client CEs is enabled.
If the clients of the RR are fully meshed, you can run the undo reflect between-clients command
to disable route reflection between the clients. The cost is thus reduced.
Step 7 (Optional) Run:
reflector cluster-id cluster-id
The cluster ID of the RR is set.
If a cluster has multiple RRs, you can use this command to set the same cluster ID for these RRs
to prevent routing loops. By default, the cluster ID is the router ID.
----End

3.12.5 Checking the Configuration

Prerequisite
The configurations of RR are complete.
Issue 03 (2009-08-20)
If the RR establishes the MP-IBGP connection with the peer group consisting of all client
CEs, run the peer { group-name | peer-ipv4-address } reflect-client command to enable the
route reflection.
If the RR establishes the MP-IBGP connection with each CE rather than a peer group, run
the peer peer-ipv4-address reflect-client command multiple times to enable route reflection.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP/MPLS IP VPN Configuration
3-51