Huawei Quidway S9300 Configuration Manual page 377

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
tunnel type: cr lsp,
conn-type: remote
tunnel type: lsp
Reroute policy
Reason of last reroute : --
Time of last reroute
delay timer ID
resume timer ID
Check the routing table on CE2, and you can see that the outgoing interface of the routes destined
for 10.1.3.0 changes to VLANIF 60. That is, the L2VPN traffic is switched back to the primary
path.
<CE2> display ip routing-table
Route Flags: R - relied, D - download to fib
------------------------------------------------------------------------------
Routing Tables: Public
Destination/Mask
----End
Configuration Files
l
Issue 03 (2009-08-20)
AC OAM state:
BFD for PW session index:
BFD for PW state:
BFD for LSP state:
Local C bit is set,
local vc state:
remote vc state:
local ce-id:
local ce name:
remote ce-id:
intf(state,encap):
peer id:
route-distinguisher:
local vc label:
remote vc label:
tunnel policy:
primary or secondary:
forwardEntry exist or not:
forward entry active or not:false
manual fault set or not:
AC OAM state:
BFD for PW session index:
BFD for PW state:
BFD for LSP state:
Local C bit is set,
,
: delay 30 s, resume 0 s
: 0 days, 0 hours, 48 minutes, 52 seconds
: --
: --
Destinations : 5
Proto
10.1.1.0/30 Direct 0
10.1.1.2/32 Direct 0
10.1.3.1/32 OSPF
127.0.0.0/8 Direct 0
127.0.0.1/32 Direct 0
Configuration file of CE1
#
sysname CE1
#
vlan batch 10 70
#
interface Vlanif10
ip address 10.1.1.1 255.255.255.0
ip address 10.1.2.1 255.255.255.0 sub
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
up
--
invalid
true
Remote C bit is set
id: 0x1003d
up
up
1
ce1
3
Vlanif10(up,vlan)
2.2.2.2
100:3
25603
25601
default
secondary
true
not set
up
--
invalid
true
Remote C bit is set
id: 0x10028
rest time :--
rest time :--
Routes : 5
Pre Cost Flags NextHop
0 D
0 D
10 2 D
0 D
0 D
4 VLL Configuration
Interface
10.1.1.2 Vlanif60
127.0.0.1 InLoopBack0
10.1.1.1 Vlanif60
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
4-115