Huawei Quidway S9300 Configuration Manual page 465

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
remote AC OAM state
remote PSN state
remote forwarding state: forwarding
BFD for PW
manual fault
active state
forwarding entry
link state
local VC MTU
local VCCV
remote VCCV
local control word
tunnel policy
traffic behavior
PW template name
primary or secondary
VC tunnel/token info
create time
up time
last change time
reroute policy
reason of last reroute
time of last reroute
delay timer ID
resume timer ID
Client1 can ping 10.1.1.2 on Client2.
[Client] ping 10.1.1.2
PING 10.1.1.2: 56
--- 10.1.1.2 ping statistics ---
Run the display mac-address dynamic command on CEs. Take the display on CE2 for example.
You can see that GE1/0/0 has learned the MAC address of Client1 (00e0-413f-8401) and
GE1/0/2 has learned the MAC address of Client2 (00e0-c279-e10a 10). This indicates that the
clients are using the master link CE2 → PE3 → P → PE1 to forward data.
[CE2] display mac-address dynamic 1
MAC Address
--------------------------------------------------------------------------------
00e0-413f-8401 10
00e0-c279-e10a
Total 2 ,2 printed
Step 8 Verify the configuration.
l
Run the display mpls l2vc interface command on PE1. If the configuration is successful, you
can see that the master PW is in Active state, the backup PW is in InActive state.
<PE1> display mpls l2vc interface Vlanif 10
*client interface
session state
AC state
Issue 03 (2009-08-20)
NO.0 TNL type : lsp
data bytes, press CTRL_C to break
Reply from 10.1.1.2: bytes=56 Sequence=1 ttl=255 time=180 ms
Reply from 10.1.1.2: bytes=56 Sequence=2 ttl=255 time=150 ms
Reply from 10.1.1.2: bytes=56 Sequence=3 ttl=255 time=150 ms
Reply from 10.1.1.2: bytes=56 Sequence=4 ttl=255 time=190 ms
Reply from 10.1.3.110.1.1.2: bytes=56 Sequence=5 ttl=255 time=160 ms
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 150/166/190 ms
VLAN/VSI
10
View the status of PWs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: up
: up
: unavailable
: not set
: inactive
: existent
: up
: 1500 remote VC MTU
: cw lsp-ping bfd
: cw lsp-ping bfd
: enable remote control word : enable
: --
: --
: 1to2
: secondary
: 1 tunnels/tokens
, TNL ID : 0x20021
: 0 days, 0 hours, 22 minutes, 19 seconds
: 0 days, 0 hours, 1 minutes, 32 seconds
: 0 days, 0 hours, 1 minutes, 32 seconds
: delay 30 s, resume 0 s
: New LDP mapping message was received
: 0 days, 0 hours, 0 minutes, 50 seconds
: -- rest time :--
: -- rest time :--
PEVLAN CEVLAN Port
- - GE1/0/0
- - GE1/0/2
: Vlanif10 is up
: up
: up
5 PWE3 Configuration
: 1500
Type Lsp
dynamic 1/0
dynamic 1/0
5-83