Huawei Quidway S9300 Configuration Manual page 91

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Assign the IP address to each interface.
<Quidway> system-view
[Quidway] sysname S9300-A
[S9300-A] vlan batch 10 30
[S9300-A] interface gigabitEthernet 1/0/0
[S9300-A-GigabitEthernet1/0/0] port hybrid pvid vlan 10
[S9300-A-GigabitEthernet1/0/0] port hybrid untagged vlan 10
[S9300-A-GigabitEthernet1/0/0] quit
[S9300-A] interface gigabitEthernet 2/0/0
[S9300-A-GigabitEthernet2/0/0] port hybrid pvid vlan 30
[S9300-A-GigabitEthernet2/0/0] port hybrid untagged vlan 30
[S9300-A-vlan30] quit
[S9300-A] interface vlanif 10
[S9300-A-Vlanif10] ip address 20.1.1.1 24
[S9300-A-Vlanif10] quit
[S9300-A] interface vlanif 30
[S9300-A-Vlanif30] ip address 10.1.1.2 24
[S9300-A-Vlanif30] quit
The configurations of S9300-B and S9300-C are similar to the configuration of S9300-A, and
are not mentioned here.
Step 2 Configure IGP on the VPN backbone network.
The configuration procedure is the same as that in
the GRE
Step 3 Configure the tunnel interface.
The configuration procedure is the same as that in
the GRE
Step 4 Configure the OSPF protocol on the tunnel interfaces.
# Configure S9300-A.
Issue 03 (2009-08-20)
Run IGP on the S9300s on the backbone network (OSPF process 1 is used here).
Create GRE tunnels between the S9300s connected with PCs so that data between any two
PCs is transmitted through GRE tunnels.
Run the dynamic routing protocol on the network segment where the PCs access the
backbone network (OSPF process 2 is used here).
IDs of the VLANs that the interfaces belong to, as shown in
IP address of the VLANIF interfaces , as shown in
Source addresses and destination addresses on the two ends of the GRE tunnel
IP addresses of the interfaces on the two ends of the GRE tunnel
Tunnel.
Tunnel.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 2-6
Figure 2-6
Example for Configuring Static Routes on
Example for Configuring Static Routes on
2 GRE Configuration
2-21