Establishing The Configuration Task; Creating A Pw Template - Huawei Quidway S9300 Configuration Manual

5 PWE3 Configuration

5.3.1 Establishing the Configuration Task

Applicable Environment
You can set the attributes for a PW through commands or a PW template. The attributes include
the peer, CW, and tunnel policy. Using a PW template can simplify the configurations of PWs
with similar attributes. The PW template is configured on U-PEs.
Pre-configuration Tasks
Before configuring the attributes for a PW template, complete the following tasks:
l
Data Preparation
To configure the attributes for a PW template, you need the following data.
No.
1
2
3

5.3.2 Creating a PW Template

Context
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
Step 3 Run:
quit
Return to the system view.
5-12
NOTE
Some PW attributes such as the MTU, PW type, and encapsulation type are obtained from the interface
connecting the U-PE to the CE directly.
Configuring basic MPLS functions
Data
IP address of the remote end of the PW
Name of the tunnel policy
Name and attributes of the PW template, such as CW and VCCV
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Issue 03 (2009-08-20)