Figure 4-4 Networking Diagram For Configuring Local Ccc Connection - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN

Figure 4-4 Networking diagram for configuring local CCC connection

CE 1
S9300
PE
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
IP addresses of the interfaces
Procedure
Step 1 Configure CEs.
# Configure CE1.
<Quidway> system-view
[Quidway] sysname CE1
[CE1] vlan 10
[CE1-Vlan10] quit
[CE1]interface GigabitEthernet1/0/0
[CE1-GigabitEthernet1/0/0]port link-type trunk
[CE1-GigabitEthernet1/0/0]port trunk allow-pass vlan 10
[CE1-GigabitEthernet1/0/0]quit
[CE1] interface vlanif 10
[CE1-Vlanif10] ip address 100.1.1.1 24
[CE1-Vlanif10] quit
# Configure CE2.
Issue 03 (2009-08-20)
CCC local connection
GE 1/0/0
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet1/0/0
Configure the basic MPLS capacity on the PE and enable the MPLS L2VPN.
Create a local connection between CE1 and CE2 on PE. The local CCC connection is
bidirectional, so only one connection is needed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
CE 2
GE1/0/0
GE 2/0/0
GE 1/0/0
PE
Loopback1
1.1.1.9/32
VLANIF interface
VLANIF 10
VLANIF 20
-
VLANIF 10
VLANIF 20
4 VLL Configuration
IP address
-
-
1.1.1.9/32
100.1.1.1/24
100.1.1.2/24
4-37