Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
The VLANIF interface view is displayed.
Step 3 Run:
l2 binding vsi vsi-name
A VSI is bound to the interface.
----End

6.4.4 Checking the Configuration

Prerequisite
The Martini VPLS configurations are completed.
Procedure
l
l
l
l
l
----End
Example
Run the display vsi [ name vsi-name ] [ verbose ] command, and you can view that VSI
State is up. If verbose is set, Signaling is bgp and VC State is up. For example:
<Quidway> display vsi name a2 verbose
***VSI Name
Issue 03 (2009-08-20)
Run the display vsi [ name vsi-name ] [ verbose ] command to view the information of a
VPLS VSI.
Run the display vsi remote ldp [ route-id ip-address ] [ pw-id pw-id ] command to check
information about a remote VSI.
Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check information about a VPLS connection.
Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about
the outgoing interface of a PW in a VSI.
Run the display l2vpn vsi-list tunnel-policy policy-name command to check information
about the tunnel policy applied to a VSI.
Administrator VSI
Isolate Spoken
VSI Index
PW Signaling
Member Discovery Style : static
PW MAC Learn Style
Encapsulation Type
MTU
Mode
Service Class
Color
DomainId
Domain Name
VSI State
VSI ID
*Peer Router ID
VC Label
Peer Type
Session
Tunnel ID
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: a2
: no
: disable
: 0
: ldp
: unqualify
: vlan
: 1500
: uniform
: --
: --
: 255
:
: up
: 2
: 3.3.3.9
: 23552
: dynamic
: up
: 0x2002001,
6 VPLS Configuration
6-17