Huawei Quidway S9300 Configuration Manual page 552

6 VPLS Configuration
Step 3 Enable MPLS and configure dynamic LSPs.
Configure basic MPLS functions on the MPLS backbone network. Establish dynamic LDP LSPs
between PEs and ASBR-PEs in the same AS.
After this step, an LSP tunnel is established between the PE and ASBR-PE in the same AS.
Take ASBR-PE1 as an example.
<ASBR-PE1> display mpls ldp session
------------------------------------------------------------------------------
Peer-ID
------------------------------------------------------------------------------
1.1.1.1:0
------------------------------------------------------------------------------
TOTAL: 1 session(s) Found.
LAM : Label Advertisement Mode
Step 4 Enable MPLS L2VPN on PEs.
# Configure PE1.
[PE1] mpls l2vpn
# Configure PE2.
[PE2] mpls l2vpn
# Configure ASBR-PE1.
[ASBR-PE1] mpls l2vpn
# Configure ASBR-PE2.
[ASBR-PE2] mpls l2vpn
Step 5 Bind VSIs to related interfaces.
Configure VSIs on PEs and ASBR-PEs respectively and bind the VSIs to related interfaces.
# Configure PE1.
[PE1] vsi a1 static
[PE1-vsi-a1] pwsignal ldp
[PE1-vsi-a1-ldp] vsi-id 2
[PE1-vsi-a1-ldp] peer 2.2.2.2
[PE1-vsi-a1-ldp] quit
[PE1-vsi-a1] quit
[PE1] interface vlanif 10
[PE1-Vlanif10] l2 binding vsi a1
[PE1-Vlanif10] quit
# Configure ASBR-PE1.
[ASBR-PE1] vsi a1 static
[ASBR-PE1-vsi-a1] pwsignal ldp
[ASBR-PE1-vsi-a1-ldp] vsi-id 2
[ASBR-PE1-vsi-a1-ldp] peer 1.1.1.1
[ASBR-PE1-vsi-a1-ldp] quit
[ASBR-PE1-vsi-a1] quit
[ASBR-PE1] interface vlanif 30
[ASBR-PE1-Vlanif30] l2 binding vsi a1
[ASBR-PE1-Vlanif30] quit
6-70
0.00% packet loss
round-trip min/avg/max = 60/98/180 ms
LDP Session(s) in Public Network
Status
Operational DU
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
LAM SsnRole SsnAge
Active 000:00:08
SsnAge Unit : DDD:HH:MM
Configuration Guide - VPN
KA-Sent/Rcv
34/34
Issue 03 (2009-08-20)