Configuring Inter-As Pwe3; Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
VC tunnel/token info
create time
up time
last change time
reroute policy
reason of last reroute
time of last reroute
delay timer ID
resume timer ID
Run the display mpls l2vc remote-info command, and you can see that Peer Addr is the peer
address of the VC. The following is an example:
<Quidway> display mpls l2vc remote-info
Total remote ldp vc : 2
Transport
VC ID
100
200
Run the display mpls l2vpn forwarding-info [ vc-label ] interface interface-type interface-
number [ | { begin | exclude | include } regular-expression ] command, and you can see that
ENTRYTYPE of the master PW is SEND, PWSTATE is ACTIVE, BFDSTATE is UP, and
ADMIN is UP. The following is an example:
<Quidway> display mpls l2vpn forwarding-info interface Vlanif 10
The Main PW Forward Infomation :
VCLABEL TNLTYPE ENTRYTYPE PWSTATE
---------------------------------------------------------------------------
21504
The Second PW Forward Infomation :
VCLABEL TNLTYPE ENTRYTYPE PWSTATE
---------------------------------------------------------------------------
21504

5.9 Configuring Inter-AS PWE3

This section describes how to configure the inter-AS PWE3. Then, the MPLS backbone network
bearing PWE3 can extend over multiple ASs.

5.9.1 Establishing the Configuration Task

5.9.2 Configuring Inter-AS PWE3-Option A
5.9.3 Checking the Configuration
5.9.1 Establishing the Configuration Task
Applicable Environment
If the MPLS backbone network bearing PWE3 extends over multiple ASs, the inter-AS PWE3
must be configured.
l
Issue 03 (2009-08-20)
NO.0 TNL type : lsp
Group Peer
ID Addr
0 3.3.3.3
0 2.2.2.2
CRLSP SEND ACTIVE
1 Record(s) Found.
LSP SEND
1 Record(s) Found.
Inter-AS PWE3-Option A: Option A is easy to implement and applicable to the scenario
where the number of inter-AS PWs is small.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: 1 tunnels/tokens
, TNL ID : 0x10004
: 0 days, 0 hours, 12 minutes, 47 seconds
: 0 days, 0 hours, 1 minutes, 32 seconds
: 0 days, 0 hours, 1 minutes, 32 seconds
: delay 30 s, resume 0 s
: Remote AC fault was resumed
: 0 days, 0 hours, 1 minutes, 38 seconds
: -- rest time :--
: -- rest time :--
Remote
Encap
vlan
vlan
BFDSTATE ADMIN CTLWORD
UP UPTRUE
BFDSTATE ADMIN CTLWORD CC CV TNLID
INACTIVE UP UP
5 PWE3 Configuration
Remote C MTU/
VC Label Bit CELLS Bit Bit
21504 1 1500
21504 1 1500
CC CV TNLID
1 8 0x10002
TRUE 1 8 0x10004
N S
1 0
1 0
5-31