Enabling Mpls L2Vpn; Creating A Dynamic Pw - Huawei Quidway S9300 Configuration Manual

5 PWE3 Configuration
No.
2
3

5.5.2 Enabling MPLS L2VPN

Context
Before configuring an MPLS L2VC, you must enable MPLS L2VPN.
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view of the PE is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
----End

5.5.3 Creating a Dynamic PW

Context
Do as follows on the U-PEs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 3 Run:
mpls l2vc { ip-address | pw-template pw-template-name }
id ] [ [ control-word | no-control-word ] | [ raw | tagged
tunnel-policy policy-name]
The dynamic PW is created.
5-18
Data
IP address of the destination of L2VC and VC ID
Name of the tunnel policy
*
[ secondary ]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
*
vc-id [ group-id group-
] | [ mtu mtu-value ]
Issue 03 (2009-08-20)