Huawei Quidway S9300 Configuration Manual page 540

6 VPLS Configuration
P
SPE2
UPE2
CE1
CE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
1.
2.
6-58
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 2/0/0
Loopback1
GigabitEthernet 1/0/0
GigabitEthernet 1/0/0
Complete the task of Configuring Martini VPLS
Configure basic MPLS L2VPN functions on UPEs and SPEs.
Configure static VLLs and VSIs on SPEs and enable MAC-withdraw function on the VSIs.
Configure UPEs to access SPEs through static VLLs.
Names and IDs of VSIs
MPLS LSR IDs of UPEs and SPEs, which are used as peer IP addresses
Routing protocol
Received and sent labels on static LSPs between UPEs and SPEs
Configure IP addresses for interfaces.
As shown in Figure 6-8, configure the VLAN to which each interface belongs, and
configure the IP addresses and masks for loopback interfaces and VLANIF interfaces.
NOTE
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may
occur.
The S9300 only allows the CE to access the PE through a trunk.
Configure an IGP.
Configure OSPF on SPEs and the P device to advertise the network segment and LSR IDs.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
-
VLANIF 30
VLANIF 40
-
VLANIF 40
VLANIF 50
-
VLANIF 50
VLANIF 60
-
VLANIF 10
VLANIF 60
between SPEs.
1.1.1.9/32
100.1.1.2/24
100.1.2.1/24
2.2.2.9/32
100.1.2.2/24
100.1.4.1/24
3.3.3.9/32
100.1.4.2/24
-
5.5.5.9/32
10.1.1.1/24
10.1.1.2/24
Issue 03 (2009-08-20)