Configuring The Rr To Establish Mp-Ibgp Connections With All Client Pes - Huawei Quidway S9300 Configuration Manual
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3.11.3 Configuring the RR to Establish MP-IBGP Connections with
All Client PEs
Context
Choose one of the following schemes to configure the RR to establish MP-IBGP connections
with the client PEs.
Procedure
l
l
Issue 03 (2009-08-20)
Configuring the RR to establish MP-IBGP connections with the peer group
Add all client PEs to a peer group and set up an MP-IBGP connection with the peer group.
1.
Run:
system-view
The system view is displayed.
2.
Run:
bgp as-number
The BGP view is displayed.
3.
Run:
group group-name [ internal ]
An IBGP peer group is created.
4.
Run:
peer ip-address group group-name
The peer is added to the peer group.
5.
Run:
peer group-name connect-interface interface-type interface-number
The interface for establishing the TCP connection is configured. The IP address of the
interface must be the same as the MPLS LSR ID. It is recommended that you specify
a loopback interface to establish the TCP connection.
6.
Run:
ipv4-family vpnv4
The BGP VPNv4 address family view is displayed.
7.
Run:
peer group-name enable
The function of exchanging VPNv4 routes between the peer group and the RR is
enabled.
8.
Run:
peer ip-address group group-name
The peer is added to the peer group.
Configuring the RR to establish an MP IBGP connection with each client PE
Perform Step 1 to Step 6 repeatedly on the RR to establish MP-IBGP connections with all
client PEs.
1.
Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 BGP/MPLS IP VPN Configuration
3-45
Advertisement
Table of Contents
