Huawei Quidway S9300 Configuration Manual page 58

1 VPN Tunnel Management
PE3
P
CE1
CE2
CE3
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Enable PEs to communicate with each other.
# Configure an Interior Gateway Protocol (IGP) on the MPLS backbone network to implement
interworking between the PEs. IS-IS is used in this example, and the IS-IS process ID is 1.
# Configure PE1.
<Quidway> system-view
[Quidway] sysname PE1
[PE1] vlan 7
[PE1-vlan7] quit
[PE1] interface GigabitEthernet 1/0/1
1-40
Loopback1
GigabitEthernet1/0/1
GigabitEthernet1/0/3
Loopback1
GigabitEthernet1/0/1
GigabitEthernet1/0/2
GigabitEthernet1/0/3
GigabitEthernet1/0/2
GigabitEthernet1/0/3
GigabitEthernet1/0/1
GigabitEthernet1/0/1
Configure a TE tunnel.
Configure a tunnel policy to bind the IP address of the remote end to the tunnel.
Apply the tunnel policy to the L2VC.
Connect the CEs to the backbone network.
Tunnel policy
VC ID
Parameters for the MPLS TE tunnel
NOTE
For different L2VPN services from a PE to the same destination, different tunnel policies and TE tunnels
are required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
-
VLANIF 3
VLANIF 6
-
VLANIF 7
VLANIF 5
VLANIF 6
VLANIF 1
VLANIF 4
VLANIF 2
VLANIF 3
2.2.2.9/32
-
100.3.1.2/24
3.3.3.9/32
100.1.1.1/24
100.2.1.1/24
100.3.1.1/24
10.1.1.1/24
20.1.1.1/24
10.1.1.2/24
20.1.1.2/24
Issue 03 (2009-08-20)