Huawei Quidway S9300 Configuration Manual page 559

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure the VLAN to which each interface belongs according to
The configuration details are not mentioned here.
Step 2 Configure an IGP on the backbone network.
Devices on the MPLS backbone network can interwork through an IGP. IS-IS used as an IGP
in this example.
The configuration details are not mentioned here. Note that IS-IS must be enabled on Loopback1.
After the configuration, IS-IS neighbor relationships are established between ASBR-PEs and
PEs in the same AS. Run the display isis peer command, and you can view that the neighbors
are Up. ASBRs and PEs can learn loopback addresses from each other.
Take PE1 as an example.
<PE1> display isis peer
System Id
0000.0000.0002
Total Peer(s): 1
<PE1> display ip routing-table
Route Flags: R - relied, D - download to fib
------------------------------------------------------------------------------
Routing Tables: Public
Destination/Mask
Issue 03 (2009-08-20)
Configure VSIs on PE1, ASBR-PE1, ASBR-PE2, and PE2 and bind the VSIs to related
AC interfaces.
IS-IS data
MPLS LSR IDs of PEs and ASBR-PEs (IP addresses of the loopback interfaces on peers)
CE IDs and CE ranges
IP addresses of interfaces connecting CEs to PEs (No IP address is required for interfaces
connecting PEs to CEs.)
NOTE
The S9300 only allows the CE to access the PE through a trunk.
Do not add the AC-side port and PW-side port of a PE to the same VLAN; otherwise, a loop may occur.
Interface
Vlanif20
Destinations : 7
Proto
1.1.1.1/32 Direct 0
2.2.2.2/32 ISIS
100.1.1.0/30 Direct 0
100.1.1.1/32 Direct 0
100.1.1.2/32 Direct 0
127.0.0.0/8 Direct 0
127.0.0.1/32 Direct 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Peer information for ISIS(1)
----------------------------
Circuit Id
0000000001
Routes : 7
Pre Cost Flags NextHop
0 D
15 10 D 100.1.1.2
0 D
0 D
0 D
0 D
0 D
6 VPLS Configuration
Figure 6-10.
State HoldTime Type
Up 20s L1L2
Interface
127.0.0.1 InLoopBack0
Vlanif20
100.1.1.1 Vlanif20
127.0.0.1 InLoopBack0
100.1.1.2 Vlanif20
127.0.0.1 InLoopBack0
127.0.0.1 InLoopBack0
PRI
--
6-77