Creating A Tunnel Interface; Configuring The Tunnel Interface - Huawei Quidway S9300 Configuration Manual

1 VPN Tunnel Management

1.3.2 Creating a Tunnel Interface

Context
Do as follows on the S9300s at both ends of a tunnel.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel interface-number
A tunnel interface is created.
----End

1.3.3 Configuring the Tunnel Interface

Context
Do as follows on the S9300s where tunnel interfaces are created.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface tunnel tunnel-number
The tunnel interface view is displayed.
Step 3 Run:
tunnel-protocol { gre | mpls te | none | ipv6-ipv4 [ 6to4 | auto-tunnel ] | ipv4-
ipv6 }
The encapsulation mode is set for the tunnel.
By default, the encapsulation mode on a tunnel interface is none. For a tunnel, use the same
encapsulation modes for the tunnel interfaces on both the ends.
The commands related to a protocol can be run only after the protocol is configured on a tunnel
interface. For example, you can run other MPLS TE commands only after the tunnel-protocol
mpls te command is run on a tunnel interface.
Step 4 Run:
destination [ vpn-instance vpn-instance-name ] destination-address
The destination address of the tunnel is specified.
1-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Issue 03 (2009-08-20)