Checking The Configuration - Huawei Quidway S9300 Configuration Manual

6 VPLS Configuration
The system view is displayed.
Step 2 Run:
vsi vsi-name static
A vsi which uses the static member discovery mechanism is created.
Step 3 Run:
pwsignal ldp
LDP is configured as the PW signaling protocol and the VSI LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The ID of the VSI is set.
Step 5 After the mac-withdraw enable command is run, when the AC or UPE fails and the VSI is Up,
the VSI can delete local MAC address and notify all remote peers of the fault.
Step 6 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
A peer of the VSI is configured.
Step 7 Run:
peer peer-address [ tnl-policy policy-name
receive-label
The local and remote labels on the SPE and the static UPE are configured.
trans on the SPE should be consistent with receive-vpn-label on the UPE and recv on the SPE
should be the same as transmit-vpn-label on the UPE.
----End

6.6.5 Checking the Configuration

Prerequisite
The actions of configuring static VLLs to a VPLS network are completed.
Procedure
l
l
l
l
l
l
----End
6-24
Run the display mpls static-l2vc [ interface interface-type interface-number ] command
to check information about an L2VPN connection in SVC mode.
Run the display l2vpn ccc-interface vc-type static-vc up command to check information
about SVC interfaces in the Up state.
Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a
VPLS VSI.
Run the display vsi remote ldp [ route-id ip-address ] [ pw-id pw-id ] command to check
information about a remote VSI.
Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check information about a VPLS connection.
Run the display mac-address dynamic slot-id command to check dynamic MAC address
entries.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
] static-upe trans transmit-label recv
Issue 03 (2009-08-20)