Huawei Quidway S9300 Configuration Manual page 317

Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
[P] mpls lsr-id 2.2.2.9
[P] mpls
[P-mpls] quit
[P] mpls ldp
[P-mpls-ldp] quit
[P] interface vlanif 20
[P-Vlanif20] mpls
[P-Vlanif20] mpls ldp
[P-Vlanif20] quit
[P] interface vlanif 30
[P-Vlanif30] mpls
[P-Vlanif30] mpls ldp
[P-Vlanif30] quit
# Configure PE2.
[PE2] mpls lsr-id 3.3.3.9
[PE2] mpls
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface vlanif 30
[PE2-Vlanif30] mpls
[PE2-Vlanif30] mpls ldp
[PE2-Vlanif30] quit
Step 4 Set up a remote LDP session between PEs.
# Configure PE1.
[PE1] mpls ldp remote-peer 3.3.3.9
[PE1-mpls-ldp-remote-3.3.3.9] remote-ip 3.3.3.9
[PE1-mpls-ldp-remote-3.3.3.9] quit
# Configure PE2.
[PE2] mpls ldp remote-peer 1.1.1.9
[PE2-mpls-ldp-remote-1.1.1.9] remote-ip 1.1.1.9
[PE2-mpls-ldp-remote-1.1.1.9] quit
After the configuration, run the display mpls ldp session command on PE1 to view the
establishment of the LDP session. You can find that an LDP session is set up between PE1 and
PE2.
Take the display on PE1 for example.
<PE1> display mpls ldp session
------------------------------------------------------------------------------
Peer-ID
------------------------------------------------------------------------------
2.2.2.9:0
3.3.3.9:0
------------------------------------------------------------------------------
TOTAL: 2 session(s) Found.
LAM : Label Advertisement Mode
Step 5 Enable MPLS L2VPN on the PE and establish VCs.
# Configure PE1: Create a VC on VLANIF 10, which is connected to CE1.
[PE1] mpls l2vpn
[PE1-l2vpn] mpls l2vpn default martini
[PE1-l2vpn] quit
[PE1] interface vlanif 10
[PE1-Vlanif10] mpls l2vc 3.3.3.9 101
[PE1-Vlanif10] quit
Issue 03 (2009-08-20)
LDP Session(s) in Public Network
Status LAM
Operational DU Passive
Operational DU Passive
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SsnRole SsnAge
000:15:29 3717/3717
000:00:00 2/2
SsnAge Unit : DDD:HH:MM
4 VLL Configuration
KA-Sent/Rcv
4-55