Huawei Quidway S9300 Configuration Manual page 438

5 PWE3 Configuration
Configure the dynamic PW on the U-PE. Enable dynamic PW switching on the S-PE.
# Configure U-PE1.
[U-PE1] mpls l2vpn
[U-PE1-l2vpn] quit
[U-PE1] interface vlanif 10
[U-PE1-Vlanif10] mpls l2vc pw-template pwt 100
[U-PE1-Vlanif10] quit
# Configure S-PE.
[S-PE] mpls l2vpn
[S-PE-l2vpn] quit
[S-PE] mpls switch-l2vc 1.1.1.9 100 between 5.5.5.9 200 encapsulation vlan
# Configure U-PE2.
[U-PE2] mpls l2vpn
[U-PE2-l2vpn] quit
[U-PE2] interface vlanif 60
[U-PE2-Vlanif60] mpls l2vc pw-template pwt 200
[U-PE2-Vlanif60] quit
Step 7 Verify the configuration.
1.
5-56
Display information about the PWE3 connection.
Display information about the L2VPN connection on U-PE and S-PE. You can see that an
L2VC is set up and the VC status is Up.
Take the display on U-PE1 for example.
<U-PE1> display mpls l2vc interface vlanif 10
*client interface
session state
AC state
VC state
VC ID
VC type
destination
local group ID
local VC label
local AC OAM State
local PSN State
local forwarding state : forwarding
remote AC OAM state
remote PSN state
remote forwarding state: forwarding
BFD for PW
manual fault
active state
forwarding entry
link state
local VC MTU
local VCCV
remote VCCV
local control word
tunnel policy name
traffic behavior name
PW template name
primary or secondary
VC tunnel/token info
NO.0 TNL type : lsp
create time
up time
last change time
Display the status of the switching L2VC on S-PE.
<S-PE> display mpls switch-l2vc
Total Switch VC : 1, 1 up, 0 down
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: Vlanif10 is up
: up
: up
: up
: 100
: VLAN
: 3.3.3.9
: 0 remote group ID
: 21504 remote VC label
: up
: up
: up
: up
: unavailable
: not set
: active
: exist
: up
: 1500 remote VC MTU
: cw lsp-ping
: cw lsp-ping
: enable remote control word
: --
: --
: pwt
: primary
: 1 tunnels/tokens
, TNL ID : 0x20020
: 0 days, 0 hours, 15 minutes, 3 seconds
: 0 days, 0 hours, 3 minutes, 15 seconds
: 0 days, 0 hours, 3 minutes, 15 seconds
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
: 0
: 21505
: 1500
: enable
Issue 03 (2009-08-20)