Selection Example Of Wires - Mitsubishi Electric MELSERVO-J4 series Instruction Manual

11. Options and peripheral devices
(3) DIMENSIONS

11.9 Selection example of wires

The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
2) Control circuit power supply lead
5) Power regeneration converter lead
34.8
POINT
Refer to section 11.1.3 for SSCNET III cable.
To comply with the IEC/EN/UL/CSA standard, use the wires shown in appendix
4 for wiring. To comply with other standards, use a wire that is complied with
each standard.
Selection conditions of wire size is as follows.
Construction condition: Single wire set in midair
Wire length: 30 m or less
1) Main circuit power supply lead
Power supply
Power regeneration
converter
Regenerative option
3) Regenerative option lead
69.3
Servo amplifier
L1
L2
L3
L11
L21
N-
C
P+
11 - 53
Rating plate
U
V
W
4) Servo motor power supply lead
[Unit: mm]
Mass: 66 [g]
M