Selection Example Of Wires - Mitsubishi Electric MR-J4 Instruction Manual

11. OPTIONS AND AUXILIARY EQUIPMENT

11.9 Selection example of wires

The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
2) Control circuit power supply lead
5) Power regeneration converter lead
POINT
To comply with the IEC/EN/UL/CSA standard, use the wires shown in appendix
4 for wiring. To comply with other standards, use a wire that is complied with
each standard.
Selection condition of wire size is as follows.
Construction condition: Single wire set in midair
Wire length: 30 m or less
1) Main circuit power supply lead
Power supply
Power regeneration
converter
Regenerative option
3) Regenerative option lead
Servo amplifier
L1
L2
L3
L11
L21
N-
C
P+
11 - 77
U
V
W
4) Servo motor power supply lead
M