Selection Example Of Wires - Mitsubishi Electric MR-J4W2 Instruction Manual

11. OPTIONS AND AUXILIARY EQUIPMENT

11.5 Selection example of wires

(1) Wires for power supply wiring
The following diagram shows the wires used for wiring. Use the wires given in this section or equivalent.
2) Control circuit power supply lead
POINT
Refer to section 11.1.2 for SSCNET III cable.
To comply with the EC/EN/UL/CSA standard, use the wires shown in appendix 4
for wiring. To comply with other standards, use a wire that is complied with each
standard.
Selection condition of wire size is as follows.
Construction condition: One wire is constructed in the air
Wire length: 30 m or less
1) Main circuit power supply lead
Power supply
Regenerative option
3) Regenerative option lead
Servo amplifier
L1
L2
L3
L11
L12
D
C
P+
11 - 29
U
V
W
4) Servo motor power supply lead
M