Remove Fan #5 (Optical Cooling Fan For Blue And Green Dmd); Remove Fan #6 (Optical Cooling Fan For Red Dmd And Prism); Lamp Power Supply; Replace The Lamp Power Supply - Christie J Series Service Manual

4.4.3 Remove Fan #5 (Optical Cooling Fan for Blue and Green DMD)

(10 minutes)
1. Remove the top cover. See
2. Remove (3) 3 mm hex screws, which secure the transparent engine duct
to the top of the engine cover. Remove the engine duct.
3. Remove (2) 3 mm hex screws, which secure the fan assembly to the air
intake duct, as circled.
4. Disconnect the fan #5 harness. Remove the fan.

4.4.4 Remove Fan #6 (Optical Cooling Fan for Red DMD and Prism)

(10 minutes)
1. Remove the top cover. See
2. Remove (3) 3 mm hex screws from the transparent engine duct on top
of the engine cover. Remove the engine duct.
3. Remove (2) 3 mm hex screws, which secure the fan to the front air
intake duct, as circled.
4. Disconnect the fan #6 harness. Remove the fan.
4.5

Lamp Power Supply

4.5.1 Replace the Lamp Power Supply

Remove the Lamp Power Supply
(20 minutes)
1. Remove the top cover. See
2. Remove the lamp module. See
3. Remove the front filter. See
4. Remove the card cage. See
5. Remove the front air intake duct. See
J Series 1000W and 1200W Service Manual
020-100725-04 Rev. 1 (07-2015)
Remove the Top
Remove the Top
Always power down and disconnect/disengage all power sources to the
projector before servicing or cleaning.
Remove the Top
Remove the Lamp
Remove the Air
Remove the Card Cage
Remove the Front Air Intake
Section 4: Parts and Module Replacement
Cover.
Cover.
Cover.
Module.
Filter.
Assembly.
Duct.
4-11