Enabling direct pass-through of HDMI, 3G, and
DisplayPort input signals
Allow the signals from HDMI, 3G, and DisplayPort inputs to pass through another projector.
1. Select MENU > Configuration > Input Settings > Enable Video Loop Out.
2. To enable passing HDMI, 3G, and DisplayPort input signals through to another projector, select
Enter.
Informing the source of signal preferences
Configure Crimson to automatically inform the video source of the preferred signal formats.
1. If you need a specific frame rate, from the display panel, select MENU > Configuration >
Input Settings > EDID Timing.
2. Select the required EDID timing and select Enter.
60 Hz is the default EDID timing.
Adjusting laser power
Change the power of the laser.
1. Select MENU > Configuration > Light Combiner > Maser Laser Power.
2. Press Enter.
3. To adjust the laser power, use the slider.
4. To confirm your selection, select Enter.
Adjusting the mix of red, blue, and green laser
Adjust the mix of the red, blue, and green lasers.
1. Select MENU > Configuration > Light Combiner.
2. Adjust the value of the laser color you selected by using more or less of it in relation to the
other two colors.
3. To confirm your selection, select Enter.
4. Repeat steps 2 and 3 for each laser color.
Crimson User Guide–Mirage HD25, Mirage WU25, Crimson HD25, Crimson WU25
020-102649-01 Rev. 1 (04-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Configuring system settings
37