About The Factory-Default Configuration; About The Adaptive Security Device Manager; C H A P T E R 5 Configuring The Adaptive Security Appliance - Cisco ASA 5550 Series Getting Started Manual
Hide thumbs
Also See for ASA 5550 Series:
- Configuration manual (1822 pages) ,
- Getting started manual (208 pages) ,
- Hardware installation manual (82 pages)
Table of Contents
Advertisement
About the Factory-Default Configuration
About the Factory-Default Configuration
About the Adaptive Security Device Manager
Cisco ASA 5550 Getting Started Guide
5-2
Cisco adaptive security appliances are shipped with a factory-default configuration
that enables quick startup. The factory-default configuration automatically
configures an interface for management so you can quickly connect to the device and
use ASDM to complete your configuration.
By default, the adaptive security appliance Management interface is configured with
a default DHCP address pool. This configuration enables a client on the inside
network to obtain a DHCP address from the adaptive security appliance to connect to
the appliance. Administrators can then configure and manage the adaptive security
appliance using ASDM.
Chapter 5
Configuring the Adaptive Security Appliance
78-17644-01
Advertisement
Table of Contents
