Asa On The Firepower 9300 Chassis Default Configuration; Isa 3000 Default Configuration - Cisco ASA Series Getting Started

ASA on the Firepower 9300 Chassis Default Configuration

!
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd enable management
ASA on the Firepower 9300 Chassis Default Configuration
When you deploy the ASA on the Firepower 9300 chassis, you can pre-set many parameters that let you
connect to the Management interface using ASDM. A typical configuration includes the following settings:
• Management interface:
• Default route through the management interface
• ASDM access—All hosts allowed.
The configuration for a standalone unit consists of the following commands. For additional configuration for
clustered units, see
interface <management_ifc>
management-only
ip address <ip_address> <mask>
ipv6 address <ipv6_address>
ipv6 enable
nameif management
security-level 0
no shutdown
http server enable
http 0.0.0.0 0.0.0.0 management
http ::/0 management
route management 0.0.0.0 0.0.0.0 <gateway_ip> 1
ipv6 route management ::/0 <gateway_ipv6>

ISA 3000 Default Configuration

The default factory configuration for the ISA 3000 configures the following:
• Transparent firewall mode—A transparent firewall is a Layer 2 firewall that acts like a "bump in the
• 1 Bridge Virtual Interface—All member interfaces are in the same network (IP address not
• All inside and outside interfaces can communicate with each other.
• Management 1/1 interface—192.168.1.1/24 for ASDM access.
CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5
20
◦ Management type interface of your choice defined on the Firepower 9300 Chassis supervisor
◦Named "management"
◦ IP address of your choice
◦ Security level 0
◦ Management-only
Deploy the Cluster from the Firepower 9300 Chassis
wire," or a "stealth firewall," and is not seen as a router hop to connected devices.
pre-configured; you must set to match your network): GigabitEthernet 1/1 (outside1), GigabitEthernet
1/2 (inside1), GigabitEthernet 1/3 (outside2), GigabitEthernet 1/4 (inside2)
Getting Started
Supervisor.