Final Gear Case Reassembly - Suzuki Intruder VZR1800 Service Manual

4-24 DRIVELINE/AXLE

FINAL GEAR CASE REASSEMBLY

Reassemble the final gear case in the reverse order of disas-
sembly. Pay attention to the following points.
• Install a new oil seal 1 and O-ring 2 to the bearing stopper.
• Install the final drive gear bearing into the final gear case with
the special tool.
# 09913-75821 : Bearing installer
• Install the oil seal into the final gear case with the special tool.
# 09913-76010: Bearing installer set
$
* Use a new oil seal to prevent oil leakage.
* The lip and spring of the oil seal A should face to the
driven bevel gear side.
• Apply SUZUKI SUPER GREASE "A" to the oil seal lip.
' 99000-25010: SUZUKI SUPER GREASE "A"
• Install the final driven gear bearing into the final gear case
with the special tool.
# 09951-16080: Bearing installer
NOTE:
The stamped mark side of bearing face to the driven bevel gear
side.
or equivalent