Suzuki Intruder VZR1800 Service Manual page 281

Step 3
1) Turn the ignition switch OFF.
2) Check the continuity between Yellow wire and ground.
$ Position sensor continuity: ∞ Ω (Infinity)
3) If OK, then measure the position sensor resistance.
4) Connect the position sensor coupler.
5) Set the EXCVA to adjustment position. (#7-2)
6) Disconnect the position sensor coupler and measure the
resistance. (between Yellow and White wires)
$ Position sensor resistance at adjustment position:
Approx. 3.1 kΩ (+ Yellow – - White)
! 09900-25008: Multi circuit tester set
% Tester knob indication: Resistance (Ω)
Is the resistance OK?
YES Go to Step 4.
NO Replace the EXCVA with a new one.
FI SYSTEM DIAGNOSIS
3
3
3
5-87